Interactions Between the Space Station Freedom Attitude Control System and Space Shuttle Remote Manipulator Controller During On-Orbit Assembly Operations
This paper presents the results of dynamics and control interaction analyses involving the Space Shuttle Orbiter, the Shuttle Remote Manipulator System (SRMS), and the Space Station Freedom...
The Effect of Mobile Transporter Motion on the Space Station Attitude Control System
The effect of Mobile Transport (MT) motion on Space Station stability and the performance of the Attitude Control System (ACS) using Control Momentum Gyros (CMGs) is assessed. Analysis...
Space Station Microgravity Analysis and Assessment
The space station will be a platform for microgravity research. For superior microgravity science, the experiment locations must experience very little acceleration in the quasi-steady...
Space Commercialization: Problems of Law and Policy
This paper focuses on executive and legislative efforts to promote the growth of commercial space industries in the United States. After a discussion of the current, situation and efforts...
Debating Steel - Connection Design
The debate about responsibility for structural-steel-connection design is among the hottest engineering disputes of our generation. Meetings have been held on the subject, articles written...
Dynamics of Nuclear Power Plant Structures with Foundation Interaction
This paper presents analyses and conclusions pertaining to a recorded earthquake motion felt at a nuclear power plant. The objective is to obtain frequency composition, assess damage potential,...
Seismic Analysis of Bridges: Simplified or Refined Approach
This paper discusses the differences of seismic responses of bridges among various analysis methods and approaches....
Dynamic Loading of a Rigid Frame Bridge
The objective of this paper is to investigate the dynamic response of a rigid frame bridge to two trucks (side by side) passing over the rough bridge deck. The rigid frame bridge is designed...
Load Rate Effects on Concrete Compressive Strength
Plain concrete cylindrical specimens from six different concrete mixes, 51 mm in length and diameter, were tested in compression quasi-statically at strain rates between 10-6/sec...
Stability of Lift Slab Structure During Construction Stage
The lift slab structures impose stability problems during the construction phase. The process of constructing this type of structure requires placing the masses of the floor slabs at a...
Seismic Response Studies on a Two Span Slab-On-Girder Bridge
A new type of self-equilibrating snap-back (quick-release) test setup is employed to investigate the transverse dynamic response of a two-span continuous slab-on-girder highway bridge....
Seismic Performance of Railway Bridges
Historically, the seismic performance of railway bridges in the U.S.A. has been very satisfactory during earthquakes of this century. There are many possible factors contributing to this...
Seismic Study of Historic Bridges in Eastern United States
The main objective of this paper is to study the Barrackville bridge and its response in resisting static and seismic loads. Since the design was based on controlled deflections, the analyses...
Statistical Response of a Class of Hysteretic Systems
The response of a hysteretic nonlinear system subjected to a filtered white noise is considered. The method of time-dependent equivalent linearization is used and the moment equations...
Progress in Reinforced Concrete Column Design
This paper reviews some of the design procedures used for both braced and unbraced frames constructed in reinforced concrete. The discussion refers to the problems of material and geometric...
Load and Resistance Factors for Bridge Design Code
The paper summarizes the code development procedures used for the new LRFD (load and resistance factor design) bridge code. The current specifications use allowable stresses and/or load...
Assessment and Upgrade of an Older Transmission Line
This paper discusses the various tools and procedures which have been used to assess and upgrade an older 130 kv tower line. The purpose of the assessment was to determine the line compliance...
Lateral Load Resisting Systems for Circular Buildings
The design of structural systems to economically limit inter-story drift and building acceleration for circular high rise buildings is presented within the framework of two recently constructed...
Criteria for Acceptable Wind-Induced Motions
This paper discusses criteria for evaluating acceptable wind-induced building motions. The paper draws on the results of moving room experiments and the performance of actual buildings...
Limit States Analysis of Masonry Arches
The limit states analysis of masonry arches, heretofore used only for the analysis of hinging mechanisms within the arch ring, is shown to have wider applicability. Lower and upper bounds...
Return to search